This listing was posted on ApplicantPro.
Z Mill Floor Operator
Location:
Ghent, KY
Description:
The Z-Mill operator is responsible for all of the operating functions of the Z-Mill listed below. Operation of the mill must be understood in total with the focus of utilizing the equipment to meet all the quality and productivity goals as outlined in our quality system. All functions of the unit are to be carried out as described in the work instructions. DUTIES1. Check coil to be run for proper identification which corresponds to the program.2. Load coil onto either the pay off reel or the tension reel.3. Feed coil through mill to opposite tension reel.4. Remove interleaving paper or plastic as required.5. Load all information into the computer for rolling parameters.6. Insert work rolls into the mill and following the rolling schedule, run the first pass at prescribed speeds according to work instructions. Periodic gauge referencing must be made during rolling. Adjust as necessary.7. Stop the mill at prescribed intervals as indicated in work instructions and inspect both the top and the bottom face of the strip for rolling defects. Change any rolls, hose wiper etc. to insure the quality of the strip.8. Insert paper into the coil during last pass.9. Once coil is completed, remove from tension reel, band and identify per work instructions.10. Enter completed coil data into the AS-400 system as well as note abnormalities (AQNS).SUPPLEMENTAL JOB FUNCTIONS:1. Coordinate movement with the crane operator for coil and roll movements.2. Communicate roll necessities with roll grinding department.3. Change rolls in the mill box.4. Grease mill unit as specified in work instructions.5. Perform daily checks as specified in appropriate checklists.6. Utilize all diagnostics as necessary.7. Calculate rolling schedules and tensions if necessary.8. Utilize paper interleaving as per work instructions.9. Perform maintenance work as assigned.10. Maintain proper housekeeping throughout the entire work area.11. Work swing shiftQUALIFICATIONSMINIMUM EDUCATION, SKILLS AND EXPERIENCE: High School Degree or Equivalent (GED)PHYSICAL ABILITIES REQUIRED:1. Mobility: Stand (stationary) - 10%, stand/walk - 20%, walking - 10%, sitting - 60%. 2. Strength and Agility: Lifting up to 70 lbs and carrying over a distance of 10 feet, and pushing or pulling 100 lbs. Occasional climbing, bending, twisting, kneeling, turning, stooping, crouching, and balancing3. Mobility in Plant.4. Ability to lift at least 50 lbs.5. Visual ability with or without correction.6. Communication ablitites.7. Ability to work rotating shift ( rotating from days to nights on a weekly or bi-weekly schedule).HEALTH AND SAFETY1. Work in compliance with the Occupational Health and Safety Act and regulations.2. Follow Company safety rules.3. Report the absence of or defect in any protective equipment or clothing to the Supervisor or Manager immediately.4. Use or wear the equipment, protective devices or clothing that is required to be used or worn:ยท Safety shoesZ Mill Floor Operator, North American Stainless
Company:
North American Stainless
Posted:
December 26 2023 on ApplicantPro
Visit Our Partner Website
This listing was posted on another website. Click here to open: Go to ApplicantPro
Important Safety Tips
- Always meet the employer in person.
- Avoid sharing sensitive personal and financial information.
- Avoid employment offers that require a deposit or investment.
To learn more, visit the Safety Center or click here to report this listing.
More About this Listing: Z Mill Floor Operator
Z Mill Floor Operator is a Construction Operator Job at North American Stainless located in Ghent KY. Find other listings like Z Mill Floor Operator by searching Oodle for Construction Operator Jobs.
Z Mill Floor Operator is a Construction Operator Job at North American Stainless located in Ghent KY. Find other listings like Z Mill Floor Operator by searching Oodle for Construction Operator Jobs.